Safety Data Sheets (SDS) provide detailed information on the safe handling, storage, and use of our products. Access these documents to ensure compliance and maintain a safe working environment.
Descriptions of coatings available with technical data on composition and application.
Please click on the following links below to download the appropriate report. For further assistance, please contact technical support at 800-848-5611
| Coating | Color | ASTM B117 SS (Salt Spray) Hours | Kesternich [Cycles] |
|---|---|---|---|
| Climacoat | Gray | 500 | 30 |
| Blue Climaseal | Blue | 720 | 30 |
| Silver Climaseal | Silver | 1000 | 15 |
| Electro-Zinc | Silver | 48 | 3 |
| Ultra Shield | Silver | 1100 | - |
| White Ultra Shield | White | 1600 | - |
| Silver CLIMASEAL over Electro-Zinc | Silver | 720 | 30 |
| ClimaShield | Silver | 765 | 30 |
Click on the link below to access official approvals and reports, including ICC-ES, Miami-Dade NOA, and Factory Mutual certifications. These documents validate the performance, safety, and code compliance of our products across a variety of regions and standards
Technical drawings can be found within the product details within each part number on the website
The screw included with the wing-nut assembly is an #8 x 2-1/8" blunt-point sheet metal screw. We suggest this screw for consistent performance of the assembly.
E-Z Ancors have been tested in 3/8", ½" and 5/8" single-ply drywall. See the E-Z Ancor product page to review ultimate pullout performance data
No, Dektite products are designed for use on metal roofs only. Elastomers, such as EPDM, are not compatible with petroleum based materials, such as asphalt.
The number of fasteners can be estimated by multiplying the Dektite base diameter by 3. Based on a 1-1/2" recommended spacing between fasteners, and a flashing base diameter of 16-1/2", it would take 35 SCOTS fasteners to attach a #8 Dektite.
We suggest SCOTS Teks self-drilling fasteners for attaching Dektite to a metal roof.
A 10.3 oz. tube will provide 24 feet of ¼" diameter beading
Yes. When used on roofs where pitch is steeper than 20 degrees, or when used on deep-ribbed profile roof panel (1-1/2" deep corrugation or more), consider using next larger size Dektite that will accommodate the same pipe diameter.
Please refer to the Approvals section above for up-to-date reports
No, typically coarse threaded fasteners are not appropriate for heavy steel, use a 12-24 Teks 4 or 5
For optimal fastener performance, the screw gun should be a minimum of 6 amps and use a maximum speed of 1800 RPM.
No, the impact may dull the drill or tip and over-torque the fastener. Only a twist drill should be used at roughly 1800-2000 RPM.