INSTALLATION INSTRUCTIONS
APPLICATION #1
Support Luminaire/ Conduit, Tubing, & Cable/ Piping with ˝" NPT
Threaded Coupler Top or Bottom Chord
1. Remove Truss-T Hanger unit from packaging.
2. Engage coupling to provide a 2-1/2" clearance between the bottom of the "T"
and the top of the coupling.
3. Precut a section of 1/2" Schedule 40 pipe to the required length for the
application.
4. Thread the pipe section into the coupling while maintaining the 2-1/2"
distance outlined in Step 2.
5. While holding on to the pipe section, insert the Truss-T Hanger Assembly
parallel through the center of the steel truss.
6. Rotate the Truss-T Hanger Assembly 90°clockwise while insuring the bottom of
the Truss-T Hanger "T" is above the top surface of the steel truss.
7. Position the Truss-T Hanger Assembly in the proper location and hand tighten.
8. Once installed, the Truss-T Hanger Assembly may be repositioned by loosening
the assembly and then hand tightening securely.
APPLICATION #2
Support Luminaire / Conduit, Tubing, & Cable/ Piping to Clevis Hanger with ˝" NPT Threaded Coupler Top or Bottom Chord
1. Remove Truss-T Hanger unit from packaging.
2. Engage coupling to provide a 2-1/2" clearance between the bottom of the "T" and the top of the coupling.
3. Rotate the Truss-T Hanger Assembly 90° clockwise while insuring the bottom of the Truss-T Hanger "T" is above the top surface of the steel truss.
4. Position the Truss-T Hanger Assembly in the proper location and hand tighten.
5. Once installed, the Truss-T Hanger Assembly may be repositioned by loosening the assembly and then hand tightening securely.
APPLICATION #3
Keps® Nut / Washer Installation
1. Remove Truss-T Hanger Keps nut / washer from packaging.
2. Using your hands, thread the Keps nut / washer (clockwise) to provide a 2-1/2" clearance between the bottom of the "T" and the top of the washer.
3. Rotate the Truss-T Hanger Assembly 90° clockwise while insuring the bottom of the Truss-T Hanger "T" is above the top surface of the steel truss.
4. Position the Truss-T Hanger Assembly in the proper location and hand tighten.
5. Once installed, the Truss-T Hanger Assembly may be repositioned by loosening the assembly and then hand tightening securely.
APPLICATION #4
Truss-T Hanger Mounted to Top or Bottom Chord of Truss System using Keps Nut / Washer
1. Remove Truss-T Hanger square nut / washer from packaging.
2. Using your hands, thread the square nut / washer (clockwise) to provide a 2-1/2" clearance between the bottom of the "T" and the top of the washer.
3. Rotate the Truss-T Hanger Assembly 90° clockwise while insuring the bottom of the Truss-T Hanger "T" is above the top surface of the steel truss.
