ITW Buildex Grid Mate PB

Grid-Mate PB™

Grid-Mate PB is ultimate fastening system for all Polymer Based (PB) and water managed Exterior Insulated Finish Systems (EIFS). Use Grid-Mate PB for attaching dense blanket or rigid insulation for parking garages, fireproofing, foundations walls and soundproofing.

gridmate pb

FEATURES

Closure fingers keep coating out of contact with fastener head, eliminating sink marks and bleed though.
2” diameter resists and distributes wind loads for a secure system.
Climacoat coating for corrosion resistance.

MODELS
INSTALLATION STEPS
APPLICATIONS
DOWNLOAD

GRID-MATE PB
PART NO.	DESCRIPTION	APPLICATION
2189900	Grid-Mate PB Washer	--
Fasteners
2311500	7 x 1-5/8”	Wood/Light Metal
2312500	8 x 2”	Wood/Light Metal
2313500	8 x 2-1/2”	Wood/Light Metal
2314500	8 x 3”	Wood/Light Metal
2315500	8 x 4”	Wood/Light Metal
2316500	10 x 5”	Wood/Light Metal
2317500	10 x 6”	Wood/Light Metal
2321500	6 x 1-5/8”	Steel Framing
2318500	6 x 2”	Steel Framing
2319500	8 x 2-5/8”	Steel Framing
2320500	8 x 3”	Steel Framing
2322500	10 x 4”	Steel Framing
2323500	10 x 5”	Steel Framing

STEP 1:
Use a 0-2500 RPM, 6 amp min. rated screw gun or cordless drill to install fasteners to wood and steel substrates. Use a hammer drill or rotary hammer to install Tapcon masonry anchors.

STEP 2:
Seat Grid-Mate washers flush with or maximum 1/16” below insulation surface. Over-driving may damage the washer and insulation.

STEP 3:
Fasteners must penetrate steel substrates a minimum of 3 pitches of threads.

STEP 4:
Replace worn or damaged bit tips to prevent damage to fastener head and its finish.

STEP 5:
Consult EIFS system manufacturers’ specifications for appropriate fastener spacing.


2010-2011 BUILDEX CATALOG	GRID-MATE PB DATASHEET